Connecting Two Arrays Of Solar Panels

Stringing solar panels in series involves connecting each panel to the next in a line as illustrated in the left side of the diagram above.

Connecting two arrays of solar panels. They can be wired in parallel. Just like a typical battery you may be familiar with solar panels have positive and negative terminals. The main advantage of this configuration is reliability. So if you connect two solar panels with a rated voltage of 40 volts and a rated amperage of 5 amps in series the voltage of the series would be 80 volts while the amperage would remain at 5 amps.

Connecting solar panels in series. On the other hand if our two solar panels have both different wattage and different voltage then parallel connection is not possible since the panel with the lowest voltage would behave like a load and would begin to absorb current instead of producing it with the. Connecting in series means joining the positive terminal of a solar panel to the negative terminal of the next solar panel until eventually you are left with one free positive and one free negative terminal of the array which are to be connected to the input either of the inverter in case of a grid tied system without a battery backup or the charge controller in case of a grid tied system. For example a 110ah battery should never be connected to a panel more than 11w without a solar controller and if you are using a solar controller you do not need a blocking diode.

If we have two solar panels with the same voltage but different wattage there is no problem.